Sensors Setup

In order to perform the Sensors Setup you will need to power up your Skynode and connect it to your PC/Laptop. Make sure to switch to Advanced Mode to get access to all Sensors configurations options.

Sensor configuration and calibration is managed through Vehicle Overview > Sensors (only sensors appropriate for the connected vehicle type are displayed). The sensor setup-status is indicated by colored indicators: green (calibrated)/red (uncalibrated). The calibration process for each sensor is guided by on-screen instructions, and is initiated by selecting the associated button.

Auterion-powered vehicles are usually factory calibrated. In most cases they will not require re-calibration.

Reset to Factory Calibration

To reset your sensors to the factory calibration, follow the steps in the image below.